Arlows 12V Cooling Fan "sucking"

from

38,04 €

incl. 19% VAT , plus (Paketversand)

From	Unit price
2	39,67 €*
3	38,86 €*
5	38,04 €*

Arlows 12V Radiator Fan 7" 209mm "priming"

Diameter

There are variations of this item. Please select the variation you wish.

Available now!

Description

AR8355 · 12 V PUSHER

Arlows 12V pusher cooler fan

Air onto the core, not pulled through it.
This item is the 12 V pusher line. The fan sits in front of the cooler and pushes air through the matrix. At idle, in traffic and at low speed there is no ram air. That is where the pusher holds temperature.

Pick the size on the variant, from 7 inch / 209 mm to 16 inch / 412 mm. Blade and housing are built for a small bay, water and weather resistant, individually balanced. Four mounting tabs clip onto the housing.

Why a pusher?

IN FRONT OF THE CORE

Pusher only in front of the cooler. Behind the cooler, toward the engine or machine, use the puller line. The wrong way, the fan fights itself.

12 VOLT

For 12 V systems, typical range 9 to 16 V. Do not put it on 24 V. Current through a relay and fuse, not the switch.

7 TO 16 INCH

209 mm for a tight duct and an oil cooler, 303 to 361 mm for a car front, 412 mm for a van and a large exchanger. The figure is the housing, the blade is smaller.

NOT ONLY CARS

Same fan on a generator canopy, hydraulic pack, CHP unit, cabinet with a heat exchanger and an agricultural cooler. The core face decides, not the vehicle.

Use cases

Radiator, oil cooler, gearbox cooler, intercooler with an auxiliary fan
Idle, traffic, hill climbs, slow speed
Standby generator, marine genset, hydraulic pack, electrical cabinet
Not a cabin fan without a guard

Technical data

Part number	AR8355, parent item
Voltage	12 V, typical range 9 to 16 V
Direction	pusher, mount in front of the core
Sizes	7 inch / 209 mm to 16 inch / 412 mm
Power	120 W or 170 W, depending on the variant
Build	flow shaped blade, individually balanced
Protection	water and weather resistant
Mounting	4 tabs that clip to the housing
Other side	choose the puller line separately

Airflow, current and height sit on the selected size. A 7 inch does not move the same air as a 16 inch.

Fitment

Measure the duct, then pick the variant. Keep a gap to the core or the blade rubs. Clip the tabs, wire the fan only once it sits. Positive through a relay, clean ground. Set the thermostat or switch so the fan comes on as temperature rises and runs on after shutdown.